5 Ways to Patch Car Tubeless Tires Effectively
How do you patch a tubeless tire on a car? Tubeless tires are a type of tire that does not have a tube or inner tube. This construction makes tubeless tires have less risk of leaks. However, keep in mind, minimal risk does not mean that the tire cannot leak at all.
The most common cause of tubeless tire leaks is because the tire valve loosens. Loose valve components will make it easier for the air in the tire to escape. If left unchecked, the air pressure in the tires will never be appropriate. To overcome this, Drivemate can pay attention to how to patch a car tubeless tire that has a leak below.
1. How to patch a tubeless tire using the tip top method
You could say, this is the safest method for patching a leaking tubeless tire. The method is to patch the leaking area from the inside of the tire. First, separate the tire from the rim. Next, clean the area where the leak occurs so that the patch is maximum. If so, Drivemate can proceed to the next step.
On the surface of the punctured tire, attach a rubber patch. Remember, install the rubber patch on the inside of the tire, not the outside. After that, press the rubber patch so that it sticks perfectly to the tire surface using a hot press. Let sit until the rubber hardens (around 10-20 minutes). When the tire is completely dry, Drivemate can use it again,
2. How to patch a tubeless tire using the string method
Next, how to patch tubeless tires can be done using the string method. Just like the tip top method, this method is often used. However, keep in mind, the string method requires high precision because it risks damaging the tire surface.
To carry out this string method, Drivemate needs a tire repair kit. The method is very easy. The first step that must be taken is to find the leak point. After that, drill a hole in the leaking area.
Once the leak area has been opened, Drivemate can immediately start patching. Take the special rubber available in the repair kit. Insert it into the hole with the hook until it is approximately 2 cm. The rubber should not all fit into the hole. Leave it until the rubber dries and then cut off the remaining part.
3. How to patch a tubeless tire using the bullet method
The bullet method is similar to the string method. The only difference lies in the rubber material used for the patch. In the string method, the rubber used is long shaped like a worm. Meanwhile, in this bullet method, the rubber patch has a bullet-like shape with one end that is sharp.
The steps are the same as the string method. Just remember, this method of patching tubeless tires using the bullet method is only suitable for use on the tire tread area. If applied to holes in the tire wall, the results will be less than optimal.
4. How to patch a tubeless tire using the umbrella method
Just like the tip top method, patching with the umbrella method is also done from the inside of the tire. Every step that must be followed is the same. The only difference is in the equipment used.
In the umbrella method, the rubber used as a patch is shaped like an umbrella handle. Interestingly, this method also uses a special clip that is attached to the patch. Its function is to ensure that the rubber patch adheres tightly to the surface of the leaking tire.
5. How to patch tubeless tires with anti-puncture fluid
Finally, Drivemate can use anti-puncture fluid as a way to patch tubeless tires. This is the easiest method because the steps are not too complicated. First, find out the cause of the tire leak. Clean the tire surface until there is no dirt left.
Next, put anti-leak fluid in the tire filling hole. You could say this liquid is a “magic substance” which works to adjust the conditions in the tubeless tire. When a hole appears on the surface of the tire, fluid will automatically fill it.
Even though it is practical, this anti-leak liquid should only be used in emergencies. Apart from the results of the patch not lasting long, the compounds contained in it can also damage the tire rim components. If left untreated, the rims will rust more quickly and even wear out.
It is impossible to predict when a flat tire disaster will occur. If you have implemented various methods of patching tubeless tires, but the results are still not satisfactory, Drivemate can get the best quality replacement tubeless tires only at Dunlop!